Skip to content
FL Wells

Place · Franklin County

How deep are wells in Apalachicola?

All water-supply wells in Apalachicola have a median reported depth of 72 ft. The middle half are between 38 ft and 250 ft, based on 94 NWFWMD records.

Typical water-supply well

Reported total depth, feet below ground

0 ft200400600ground surfaceCasing ~60 ftmedian cased depthMedian 72 fthalf are shallower38–250 ftmiddle half of wells

Depth by well type

Household wells are the headline because that’s what most people planning a well need. Irrigation wells are often much shallower.

Reported well depth by well type
Well typeWellsMedianMiddle half
Household13300 ft200–400 ft
Irrigation7760 ft38–120 ft
Public supply4—too few
All water-supply (headline figure)9472 ft38–250 ft

How depths are spread

All water-supply wells: number of wells per depth band (ft)

020400–50 ft: 36 wells50–100 ft: 19 wells100–150 ft: 7 wells150–200 ft: 2 wells200–250 ft: 6 wells250–300 ft: 1 well300–350 ft: 4 wells350–400 ft: 4 wells400–450 ft: 9 wells450–500 ft: 5 wells500 ft or deeper: 1 well0100200300400500+median 72 ft
Show as table
DepthWells
0–50 ft36
50–100 ft19
100–150 ft7
150–200 ft2
200–250 ft6
250–300 ft1
300–350 ft4
350–400 ft4
400–450 ft9
450–500 ft5
500 ft or deeper1

Look up wells near a specific address

Area figures blend very different places. For the wells closest to a property, with links to each original record, search an address.

Or browse every well around the center of Apalachicola →

About these numbers

  • Sources: Northwest Florida Water Management District (191 records). Records were fetched October 25, 2026.
  • What’s counted: wells with a reported depth whose use is household, irrigation, public supply or agricultural. Monitoring wells, injection wells, plugged wells and permits that were never drilled are left out. Methodology.
  • Dates: the source layer for this area publishes no construction or permit date, so we can’t say how recent these wells are.
  • Approximate locations: 55 of 191 records (29%) share their exact map point with at least four other records, so they’re probably placed at a section, subdivision or parcel-group center rather than at the well. That matters for “nearest well” distances, less for area figures like these.
  • Not a guarantee: a record shows how deep one well was permitted or built. It doesn’t predict yield, water quality or what your well will need.

Questions

How deep are wells in Apalachicola?
All water-supply wells in Apalachicola have a median reported depth of 72 ft. The middle half are between 38 ft and 250 ft, based on 94 NWFWMD records.
Will a new well at my property in Apalachicola be this deep?
Not necessarily. These are depths other wells were permitted or built to. Depth depends on the aquifer, water quality, use and local rules. A Florida-licensed water well contractor and your water management district can tell you what a new well at your property needs.
Where does this data come from?
From public well-construction records published by the Northwest Florida Water Management District. Each well in the lookup links to its original agency record.